Then weld it on.

 The roof skin was put on and taken off about half a dozen times. I can't rush getting it right. The last thing to do is test fit the back glass.

It's time to punch the holes, apply weld through primer and test fit one more time. Then apply the panel adhesive to the roof supports.

 The roof has arrived and now its time to move forward. With some help I set the roof on

Gotta do a little trimming. The only sheet metal I'll use is AMD.

1st fitting

 I sanded to top and then painted with POR 15

The painter's tape is to make sure the POR 15 does not get on the weld through primer 

 I've ordered the new roof but it is on backorder so I've the time to sand frame and  check for straightness.

The corner where the tree fell on it is crushed down so I setup my Porta-Power and pushed the frame back up where it needed to be.